Rear Axle Lubricant Replacement (10.5 Inch Axle)

Rear Axle Lubricant Replacement (10.5 Inch Axle)

Removal Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .




2. Remove the rear axle fill plug.




3. Remove the rear axle drain plug.
4. Drain the lubricant into a suitable container.
5. Inspect the drain plug for excessive metal particle accumulation. This accumulation is symptomatic of extreme wear.
6. Clean the drain plug.



Installation Procedure


Notice: Refer to Fastener Notice .





1. Install the rear axle drain plug.

Tighten the rear axle drain plug to 33 N.m (24 lb ft).

2. Fill the rear axle. Use the proper fluid. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations .




3. Install the rear axle fill plug.

Tighten the rear axle fill plug to 33 N.m (24 lb ft).

4. Lower the vehicle.